Chevrolet Cruze Forums banner

How much of a pain in this to install?

1K views 8 replies 6 participants last post by  AlaskaCruze’n 
#1 ·
#2 ·
There was someone on here who posted theirs a couple weeks ago. Looked a lot better than I expected. I can see some work needing to be done - it's a fiberglass molded part so I'm sure there's going to be a bit of sanding and finishing to get the fit perfect and then a good amount of paint work to get it perfect.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top