[Cocoabeans]

The "flasher" in the Gen1 was all in the BCM software. I doubt if Gen2 would have moved away from that. I've never heard of software update/tune to change that.

I think load resistors is the best/safest route.

Yeah I tired to change my Gen2 turn signals twice and I had hyper flashing issues. Does anyone know the correct load resistor requirement for them? I have some leftover resistors from a previous project and I wanted to make sure I could use them before I buy more...

 

[Cocoabeans]

I got some resistors from @Diode Dynamics think theyre 6ohm 50w. I hate the scotch-locks they include so I soldered mine in. Black wire is ground and middle wire is the turn signal...at least it is on Gen1

https://www.diodedynamics.com/led-resistor-kit-pair.html

I'm a look into it because so far in my experience (with LEDs for the turn signal bulbs) they cause hyperflashing so I know I need load resistors, just wasn't sure about the ohms. As mentioned before I have some 50w 6 ohm load resistors from a previous project and the link you posted was for the same specs on the resistors I already have. I'm hoping this will suffice.