Joined
·
16 Posts
I have a question if you are around Sir, I would GREATLY appreciate it
Posts by 6010LongRod
1 - 8 of 142 Posts
Joined
·
16 Posts
I tried to set time without the special tools, and I believe I got the exhaust cam one tooth off, my question is how can I adjust it that one tooth without the tools? I'm not buying them, I don't have time to wait for them to get here anyways. I have a welder, so if it's truly absolutely 100% not possible without them, im not opposed to making them myself.
It runs, just pourly
It runs, just pourly
Joined
·
16 Posts
Do you happen to own said tool?
Joined
·
16 Posts
Is there any chance you could measure the important points that it touches on the cam phasers ?
Joined
·
16 Posts
Thank you so much!! It fits on a piece of paper, perhaps you could just trace it to make the template, and then scan it if you have a scanner? Then I could just print it out and fabrication is very straightforward from there
Joined
·
16 Posts
Man, you are awesome Sir. A real life saver.????
Joined
·
16 Posts
Hey Eddie, what is the dimensions of Tool D, the crank locking pin?
Joined
·
16 Posts
Hey Eddie, can I send you a short video clip of something and possibly get your input/ideas on wtf is going on with this motor?
1 - 8 of 142 Posts
