Chevrolet Cruze Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
76 Posts
Revisited my intake today, since I was getting some oil on backside and throttle body, dripping on my trans and then the driveway.

I had about 3oz of oil in my intake, and the silicon i used on the screw to seal the hole for the missing checkvalve was gone. Either i did not clean the plastic well enough, or the silicon wasn't resistant.

I drained the oil, cleaned it again, REALLY cleaned it again, and got some oil safe epoxy.

I re-examined the checkvalve and after a year, it still was breaking with a tiny bit of pressure and re-sealing. no oil was in the tube or check valve.

After a tank or two of fuel, i'll re-report.

Thank you again, Xtreme
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top