Chevrolet Cruze Forums banner
1 - 1 of 5 Posts

· Registered
20 Posts
I recently discovered I had one of these studs broken. Rather than replace with 5/16", I used bigger 3/8" bolts. One side went in as-is, the other side downstream flange had to be opened slightly with a carbide drill (The flange is hard, and will ruin a common drill bit). Also opened gasket bolt holes slightly with a Dremel.
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.