[iTz SADISTIK]

Diode Dynamics has a great kit and is a vendor on here. I'm going to tap into the dome light and I'll post a picture later of the harness you will tap into for power. My LED strips will be here this week and I'll install them next week

 

[iTz SADISTIK]

In my opinion it's the easiest way as the harness pulls right out of the side of the car and bends down far enough you can work on it. Will turn the lights on when the doors are open. You can do a fuse with a switch if you want control over the LEDs instead. I'll take a pic of the harness and if you PM me your email address I'll send you instructions from my door sill plate install which shows you exactly how to get to said harness step by step. I'm going to wire mine into my door sill plates vs the harness because the plates are already connected to the dome light and easier to get to for me.

 

[iTz SADISTIK]

Yes, that's the panel that gets you access. It pulls straight out. Refer to the instructions I sent you as it shows it being removed.

 

[iTz SADISTIK]

Couldn't tell you. I'm just using 8 LED strips that I'll wire to the dome light. No control module or fuses for me as the dome light is already fused. Remember, wires are fused for the wire's rated load not the equipment on the wire. If I were to do a kit I'd be going through Diode Dynamics. Good luck.

 

[iTz SADISTIK]

More pics on my build thread too


Sent from iFail Mobile