Chevrolet Cruze Forums banner
1 - 1 of 3 Posts

· Registered
78 Posts
I have always jacked a few inches behind front jack point on pinch weld. Just enough so the jack stand will sit in notch. This will jack up whole side of car and you can place rear jack stand under rear notch. I picked up a pinch weld block off amazon for around 7 or 8 bucks and there is no damage to metal. Essentially a hockey puck but taller with the slot.
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.