Chevrolet Cruze Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
179 Posts
No worries if you were to bend the pinch-welds. They are not very strong, and once they are bent, you can use them each time you need to jack it up. I've bent many in my day, and had no bad results from it. I have't raised mine yet, but i'll look in my owners man, and see what they say, but if i bend it, i bend it a little. I enjoy turning wrenches everyonce in a while, now that i don't do it for a living anymore :).

And yes, the Rhino ramps should work great, i've never had an issue w/ them, with the exception of a rear-wheel drive vehicle like to push them forward.

I'm not too sure i would try Studlee's method though, feet & legs are a necessity:)
- Dan
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top