Chevrolet Cruze Forums banner

Left (driver) side rear window vent glass leak

4176 Views 6 Replies 4 Participants Last post by  ChevyGuy
I found this forum through google, and it seems like a good place to get some advice on my 2011 Cruze. We've been getting slammed with rain the past few weeks, and I started noticing water was puddling in the left rear seat. I finally was able to start investigating it today, and the water is coming through the inner seal on the inside of the window vent glass, and leaking through the post where that secures the airbag cover that recedes back to the rear window (I have pictures for clarification). I'm able to get it to leak after spraying the door/window area with a water hose for about 30-45 seconds. When it starts leaking, it's actually more of a steady light stream coming through the area circled in the attached pictures. Is this a seal that can be replaced/siliconed, or does the whole vent glass have to be replaced? The local dealership can't look at it until next week, so I'm trying to come up with a way to prevent more water from getting in. If it has to be replaced, is this a job that can be tackled pretty easily? Any help will be greatly appreciated!

The car is a 2011 with 67K on it. We bought it used from a Honda lot, so I doubt we'll have any kind of warranty on it.


Plant Plant stem Rim Nepenthes Perennial plant
Wire
Automotive exterior Vehicle Auto part Glass Automotive window part
Road
1 - 3 of 3 Posts

· Registered
Joined
·
10 Posts
Discussion Starter · #4 ·
Thanks for the replies. I had assumed the bumper to bumper was already out of the question, but it's good to know for sure.

I believe I'm going to give the Permatex a try and see if that helps it any. I'd hate to have the whole thing replaced, because I'm sure it's going to be pricey if done by a shop.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top