Chevrolet Cruze Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
61 Posts
Discussion Starter · #1 ·
Hello All,

Need to find the jack points for my Cruze. The manual indicates the jack points if I am using the scissor jack. But if I use a floor jack on the pinch weld I'll damage the car. Some mechanic at some point did that to my minivan the pinch weld near the rear wheels is completely flat. . .

Up front on the cruze I can find the frame. But where can I jack the Cruze at the back? I want to put my summer tires on and don't want to use the scissor jack to do it.

Thank you.
 

·
Registered
Joined
·
61 Posts
Discussion Starter · #4 ·
I couldn't figure out where on the control rod was a good spot so I ended up using the scissor jack again. I'm going to either make an adapter for the saddle or buy one for the fall. TIRED! Changed the wheels on two vehicles then washed the salt off the wheels before putting them away.

What a nice day though!! Now just need to pump up eight tires, they're a few pounds low.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top