Chevrolet Cruze Forums banner
1 - 1 of 1 Posts

·
Premium Member
Joined
·
5,157 Posts
Unibody frame rails for the front.

For the back I either jack the front sky-high, or jack on the flat part of the spring perch on the rear torsion beam. I figure it's meant to support 1/4 of the car's weight anyhow. IIRC there is another flat area right ahead of the rear wheel. Your floor jack might need a hockey puck or several bolted together to get at it, though!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top