[16Cruze84]

Recently, my gen 2 cruze’s clutch has been sticking to the floor. Sometimes it work. Perfectly, sometimes there’s absolutely 0 pressure and I can’t even drive my car, and sometimes it can be pushed in and will retract slowly or not at all. This just started happening after getting like a foot of snow for several days. Has anyone else had transmission, clutch, or gearbox problems in their manual trans cruzes?

I have a 2016+ Cruze 6 Speed. I had that problem only once after doing a CDV Delete. It was the Slave cylinder leaking. Pop your hood, locate the brake fluid reservoir for the clutch system. Check it for leaks. Then follow the hose to the slave cylinder and check it for leaks. You should have someone pumping your clutch during this leak check. I replaced my slave cylinder and bled the system. No further issues.

 

[16Cruze84]

I have a 2016 Cruze 1.4L 2nd Gen LE2 6-Speed Manual. The only issue I have noticed with my clutch is that sometimes the pedal is really stiff and hard to press but that usually goes away after a few minutes or so and the rest of the time it feels normal. The longest it ever did that was half a day.

Also, I think my throw out bearings are going bad because when I’m in Neutral with my foot off the clutch pedal you can hear an audible metal rattling sound and you can feel it too, but when you press the clutch in it immediately goes away and immediately comes back when you release the clutch at idle in neutral. Any help is much appreciated.