thanks for your informationItd be plug into your drivers power wire for the low beam. The harness will replace the plugs your currently using. Un plug it from the ballast and plug the pin into the power and tape everything off. Run your harness and plug your plugs from the new harness into the ballasts. Tape the passenger plug off aswell as to not get any water/debris in it.![]()
Morimoto H& HID Install
Need a little help here.
I swapped out my factory headlights with WinJet Projectors and just installed Morimoto H7 HIDs in my car.
Currently everything is run through the factory harnesses and wiring. The kit came with a heavy duty relay and wiring harness and most of it is pretty simple to install, but I can't find the OEM input that turns on and off the relays. Please see the photo. Has anybody installed one of these HID kits?
![Diagram Line Parallel]()
Thanks
I swapped out my factory headlights with WinJet Projectors and just installed Morimoto H7 HIDs in my car.
Currently everything is run through the factory harnesses and wiring. The kit came with a heavy duty relay and wiring harness and most of it is pretty simple to install, but I can't find the OEM input that turns on and off the relays. Please see the photo. Has anybody installed one of these HID kits?
Thanks
