Chevrolet Cruze Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
621 Posts
Itd be plug into your drivers power wire for the low beam. The harness will replace the plugs your currently using. Un plug it from the ballast and plug the pin into the power and tape everything off. Run your harness and plug your plugs from the new harness into the ballasts. Tape the passenger plug off aswell as to not get any water/debris in it.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top