My ZZP gauge pod install.
2157
14
Finally got around to installing my ZZP gauge pod. I must say, it fits perfect. Great job, ZZP. All thats left is the wiring. Have to figure out where to connect the dimming/light wire. Im assuming i can tap into some wire right at the switch? Also, Im thinking of using fuse #6 as the switched and #5 as the constant?
Anyway, the most PITA part was getting the factory pillar trim off. Plan on buying a new one and the big clip. I already bought the big clip ahead of time from reading others posts. You'll be lucky if that middle clip tab doesnt break.
Picture below.
![Vehicle Automotive lighting Motor vehicle Hood Automotive tire]()
Anyway, the most PITA part was getting the factory pillar trim off. Plan on buying a new one and the big clip. I already bought the big clip ahead of time from reading others posts. You'll be lucky if that middle clip tab doesnt break.
Picture below.
1 - 2 of 2 Posts
1 - 2 of 2 Posts
