Chevrolet Cruze Forums banner
1 - 5 of 5 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have a 2012 Cruze LT. I want to replace the stock exhaust with something beefier sounding. Can I do this with Just a weld on after market exhaust like magnaflow muffler? Found a magnaflow for like 80 bucks. Will this exhaust make a very noticeable difference in the sound. I dont want to throw away $80 if the sound is like a weed eater. Or do I have to have a complete exhaust system installed from the engine all the way to the muffler? Thinks for any input!
 

· Registered
Joined
·
195 Posts
Can I do this with Just a weld on after market exhaust like magnaflow muffler? Will this exhaust make a very noticeable difference in the sound? I dont want to throw away $80 if the sound is like a weed eater.
Replacing the muffler will make a difference yes but, it will never sound like a sbc. The only exhaust that had a little rasp to it the guy had a catless down pipe and mid pipe with an aftermarket muffler. The stock exhaust flows fairly well already though. Go on YouTube and look up all the flowmaster and borla exhausts.
 

· Registered
Joined
·
2 Posts
Discussion Starter · #4 ·
Ok thanks for the reply. But educate me on that. I wouldn't even know where to start. If I just cut out the resonator what kind of tone would I have. This is just a stock everything LT. If I will get a better sound with a weld on magnaflow ill just do that. If not ill chop off the resonator. What do u think?
 

· Registered
Joined
·
195 Posts
Ok thanks for the reply. But educate me on that. I wouldn't even know where to start. If I just cut out the resonator what kind of tone would I have. This is just a stock everything LT. If I will get a better sound with a weld on magnaflow ill just do that. If not ill chop off the resonator. What do u think?
This guy just replaced the muffler. Gives you an idea.. Magnaflow 14805. He is a member on here.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top