Chevrolet Cruze Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
My 2013 1.8 auto needed a new engine. I've replaced the engine only, using the original harness.
After I finished hooking everything back up and filling the oil and coolant, it has a no crank issue.
There is power at the starter and if you jump the solenoid it will crank but not start.
With the key on, all lights on the dash come on, but if I turn the key to crank, the dash and display lose all power and no sounds or cranking happens.
I've checked all fuses and relays. I'm running out of things to check before I start taking everything apart again.

I'm hoping someone here can think of some ideas that I cant think of.
Thanks for any help!
o_O
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #5 ·
I went through and checked every connector on the wiring harness.
I checked the wire from the rack. It looks fine, it is not something I touched during the engine replacement.
I've jumped the negative battery cable to rule that out.

I'm starting to think it is the antitheft or immobilizer. Does anyone know a specific way to reset this? Im reading so many different methods online.
 
1 - 2 of 2 Posts
Top