Chevrolet Cruze Forums banner
Cancel

P2135 code Engine power reduced

23470 Views 7 Replies 7 Participants Last post by  Cavid Shirxanzada, 
H
Hey guys. So on Wednesday during the blizzard in the Midwest region, my 2012 Cruze Eco MT check engine light came on. Soon after, three messages showed up on the DIC: Service stabilitrac, service traction control, and engine power reduced. I shut the car off, turned it back on, and the engine went back to normal power mode. However, the check engine light persisted. The code it is throwing is P2135, which is throttle/pedal position sensor/switch A/B voltage correlation. I was wondering if anyone else has experienced this code, or the related symptoms, and how I would go about resolving this.


Upon startup, the car starts fine, but after about five minutes switches to engine power reduced mode. Also, the temperature here is 15 degrees F.


Thanks.
Save Share
Reply Quote
1 - 1 of 1 Posts
KenH

· Registered
Joined
·
40 Posts
#4 ·
Oh my!

Other than a Chevy Cruse which car brand and model do you and poster MadelynMarkwood below recommend?
Seriously, after reading about all of the horror stories with owning a Cruze, I better sell mine before my luck runs out. :welcome:

Welcome to you MadelynMarkwood. :welcome:
 
1 - 1 of 1 Posts
Chevrolet Cruze Forums
CruzeTalk.com forum, news, discussions and the best community for owners to discuss all things related to the Chevy Cruze.
Full Forum Listing
Explore Our Forums
General Discussion Gen1 1.4L Turbo Gen1 Service Issues CruzeTalk New Member Introductions Gen1 Appearance, Body, Detailing, & Interior
Top