Chevrolet Cruze Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
127 Posts
Discussion Starter · #1 ·
I installed my PAC and used it, changed all the gains to where I felt proper.. then i noticed my woofer wasnt kicking but the amp was geting remote power. The left channel died, then the right channel just go wonky and only sends what seems like half the power it did from when i installed it to my 6x9's. wtf im so mad.
 

·
Administrator
Joined
·
15,754 Posts
I installed my PAC and used it, changed all the gains to where I felt proper.. then i noticed my woofer wasnt kicking but the amp was geting remote power. The left channel died, then the right channel just go wonky and only sends what seems like half the power it did from when i installed it to my 6x9's. wtf im so mad.
May have gotten a defective unit?
 

·
Registered
Joined
·
127 Posts
Discussion Starter · #3 · (Edited)
this was more venting than not -.- my bad

i didnt unplug the pac immediately, i just dropped that gains to zero cause I didnt have time, it ended up blowing my 6x9's im happy my woofer was unplugged.
 

·
Registered
Joined
·
199 Posts
The PAC in my Trailblazer came out of the package with one dead channel. It's running a single sub so I didn't worry about it. It's been working with one channel since 2007.
 
1 - 5 of 5 Posts
Top