Chevrolet Cruze Forums banner
Cancel

Plastic Trim Piece Warping! Is Replacement as Simple as it Looks?

5079 Views 2 Replies 2 Participants Last post by  blr5455, 
B
On my 2014, 1LT RS, the triangular plastic trim piece that follows the back door window line is beginning to warp and pull away from the car. (On the passenger side.) Could be the sun is getting to it.

GM calls this trim piece an "applique", part number 95991483. A closer look at the piece on line shows me that it looks like it just snaps into the vehicle with three plastic "attachers". It's not an expensive piece at all.

Any tricks or surprises to remove the warped one currently on the car? Can I just gently tug it off?

Any tricks or surprises to install the new one? Does it just snap in?

Appreciate hearing your experience or recommendations, since one never knows if adhesive is involved, etc. Is this fix as simple as it looks?

Thanks in advance, Cruze experts.
Save Share
Reply Quote
1 - 3 of 3 Posts
KillerDad

· Registered
Joined
·
114 Posts
#2 ·
pull hard and it wil pop right off. Mine was missing the chrome piece so i ordered a new one from ebay for like 15 bucks. new one pops right back in place. they have the 3 clips and a little 3m tape.
 
Save Share
Reply Quote
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Chevrolet Cruze Forums
CruzeTalk.com forum, news, discussions and the best community for owners to discuss all things related to the Chevy Cruze.
Full Forum Listing
Explore Our Forums
General Discussion Gen1 1.4L Turbo Gen1 Service Issues CruzeTalk New Member Introductions Gen1 Appearance, Body, Detailing, & Interior
Top