Chevrolet Cruze Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
This whole situation is rather interesting but i'm going to do my best to explain the situation as best as possible, please bear with me. This is all for a 2013 Chevy Cruze Eco.

I was in the market to change my wheels and acquired a set of XXR 530 18x7.5 rims. They have a bolt pattern of 5x100 which is different from the Cruzes' 5x105 bolt pattern so I acquired a set of 1in thick bolt pattern adapters. I'm not able to post links but to get a better visual of what i'm trying to explain simply google "5x105 to 5x100 adapters". When putting the adapters on, the stock wheel lugs are too long and stick out past the hole in the adapters causing the rim to not sit flush against the it. From the research I've done it appears I have two options if I wish to keep this setup. Option 1 is to grind down the lugs (only about a half centimeter) so that the rim can sit flush. This seems like the 'easier' , but at the same time feels somewhat sketchy. Option 2 is replace all the lug around the car with shorter ones. I contacted a local dealership and they pointed me to a lug that works and is 10mm shorter at $2.39 each (~$50 for the entire car). The issue with this is, if my research is correct, replacing the lugs on a Chevy Cruze requires you to detach the brake caliper and get behind the wheel hub.

I would just like to know what other peoples ideas and suggestions are about this. I appreciate any and all feedback.

Option 3 is always just to just return everything and work out a new setup as well but i'd like to see if this current setup is possible.
 
1 - 2 of 2 Posts
Top