Chevrolet Cruze Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter · #1 ·
I just found an old pair of ZXE's I was gonna put into the cruze until I decide to order up some LED's. Unfortunately this is my first car newer than 2000 and having some problems.

I took apart the stock tubing on the passenger side to get at the dust cover, managed to get it off and then couldn't figure out how to get the bulb out. I don't have the smallest hands so it was a bit tight but my question is do I need to remove the silver ring holding in the bulb or should I be able to pop it out without removing it? Didn't want to force anything too hard but couldn't even pop off the connector to the bulb from the angle I was at.
 

·
Registered
Joined
·
19 Posts
Discussion Starter · #3 ·
I just found an old pair of ZXE's I was gonna put into the cruze until I decide to order up some LED's. Unfortunately this is my first car newer than 2000 and having some problems.

I took apart the stock tubing on the passenger side to get at the dust cover, managed to get it off and then couldn't figure out how to get the bulb out. I don't have the smallest hands so it was a bit tight but my question is do I need to remove the silver ring holding in the bulb or should I be able to pop it out without removing it? Didn't want to force anything too hard but couldn't even pop off the connector to the bulb from the angle I was at.
Is this the headlight or fog light bulb? Do you have stock headlights? If so, all you do is twist the bulb, it'll only twist one way.
Yeah they're the stock bi-halogen projectors. I'll go take another look here.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top