Take a photo of the side of the sunroof while open so I can see the adjuster design.
Rob
Rob
Not all of the build is affected.....a rather short vin range is involved....but yes, the OP should verify his is not affected.There is a recall for these sunroofs, I wouldn't mess with it, and I would take it right to GM.
What vin is affected? Where can I see that info?Not all of the build is affected.....a rather short vin range is involved....but yes, the OP should verify his is not affected.
Rob
Take a photo of the side of the sunroof while open so I can see the adjuster design.
Rob
If the sunroof opens into the headliner it is a aftermarket install.......each version has its own adjustment proceedure. The installation company will have to adjust it.This sunroof opens into the headliner...
the recall is not due to window position or leaking. the recall is due to the window breakingThere is a recall for these sunroofs, I wouldn't mess with it, and I would take it right to GM.
If the sunroof opens into the headliner it is a aftermarket install.......each version has its own adjustment proceedure. The installation company will have to adjust it.
Since the unit is not supplied by GM there is no recall to be concerned with.
Rob
My 2014 Camaro's sunroof doesn't open into the headliner... Probably a restriction with the already low headroom. Kind of sucks though, the sunroofs that open into the headliner look a lot nicer IMO.Since when don't sunroofs open into the headliner. I have never seen a sunroof that slides back not go into the headliner on any gm vehicle in this century.
EDIT: I guess when I think about it grand am's and alero's opened outside.
Well my bad then. I knew that was how the cruze was, both of my mom's suburbans were that way, and a family friends equinox was that way. It has been a long time since I had seen one that didn't go inside the headliner. The headroom thought makes sense though as it isn't really a big issue in any of the vehicles I mentioned.
You can adjust it. On each side there is a panel you need to remove, looks like a little louver. It just slides off the top part connected to the glass.
After you remove this you will see the screws that you can loosen and adjust. You can do it by yourself but easier with 2 people. You will need a star bit to do this.