Chevrolet Cruze Forums banner
Cancel

UG and ECM Volt Too High

2176 Views 4 Replies 2 Participants Last post by  Kalpazan, 
K
Every now and then when I start the engine and Ultra Gauge will prodice "ECM Voltage Too High" alert. Measured ECM voltage at that time is 14.90. A minute later and voltage drops to ~14.50. This looks pretty normal to me and I would raise the UG ECM voltage limit to say 15.00 but wanted to make sure first. So, any opinions and spiritual philosophies about that?
Save Share
Reply Quote
1 - 3 of 3 Posts
K

· Registered
Joined
·
54 Posts
Discussion Starter · #3 ·
Thanx! I just checked UG manual and there min alarm for battery voltage is off (?) and max alarm is 14.9. I think I will turn off max alarm and set min one to say 13.80 (found that on Internet).
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Chevrolet Cruze Forums
CruzeTalk.com forum, news, discussions and the best community for owners to discuss all things related to the Chevy Cruze.
Full Forum Listing
Explore Our Forums
General Discussion Gen1 1.4L Turbo Gen1 Service Issues CruzeTalk New Member Introductions Gen1 Appearance, Body, Detailing, & Interior
Top