All you people out there with an UltraGauge. What Power Off Detect mode do you use? I put mine on the recommended 0 mode. It sat for 2 weeks and my battery was totally dead (at least I am assuming it was the UltraGauge that did it).
I'm not sure what setting I have mine on (pretty sure it's whatever it came from the factory on), but I have not had this issue. My gauge has always turned off within a minute or two after I shut the car off.
Thanks, that's what mine was set at as well. It shuts off quickly after I shut the car off, but after it sat two weeks it was dead. I was reading in the manual that the wrong setting will keep some of the modules in the car from shutting down - causing a dead battery. I was just curious. Thanks for the reply.
My wife and I bought a 2014 Cruze Diesel a little over a year ago and it has been a terrible experience. Long story short, we routinely have a "chugging" problem. After going to the shop/dealer countless times and them doing regens and other work to it, I found this forum and the...
I'm assuming the ECM is the thing on the front end of the battery but I'm not sure which number is the Serial number.
Edit: After googling all of the numbers I'm pretty safe to assume that it's the glow plug controller not the ECM, and now im clueless as to where the ECM even is.
I bought my second diesel cruze and am getting ready to tackle changing the turbo. Has anyone done one before and if so is there any special tools needed? Also any pointers would be greatly appreciated.