[WhiteCruzeGuy]

I thought the hose leading to the outlet was bad and replaced it. Then it kept leaking. I pulled it off and cleaned things up. By squeezing the main hose I discovered the pinhole leak right on the seam and in the corner, which is what you see in the video (not yet uploaded).

I thought of how many people solve their problems with JB Weld, so I used some RTV that was left over from the valve cover. Hopefully it works good enough.

 

[WhiteCruzeGuy]

That will blow out sooner than you think. Replace the outlet asap.

Yeah, this one was brand new. Definitely getting an aluminum one which I wish I knew about before.

 

[WhiteCruzeGuy]

I ended up ordering a ZZP outlet. Bc if that one fails, I'll at least get good customer service. I noticed that they use the same photo as the Mitzone one on Amazon.