Hello, I have a 2016 Cruze with the 2.0 diesel. This week the check engine light came on. I put a code reader on it and it shows 1 fault and 1 fault pending. When I go to read the codes this is what I see. "N/A 01/01 and N/A 02/02". I am assuming the 01/01 and 02/02 mean one of one and two of two but not sure what the N/A means. When I clear the codes the check engine light will stay off as long as you are driving it but when you turn the car off and go to start it the next time the light comes back on in less than a minute. Have the same number of codes and the same codes when I check them again. Any ideas?
ramrod
Unless you're outside the US, yours would need to be a 2014 or 2015 to have the 2.0L LUZ turbodiesel.
I presume the N/A are like what I see when I use my cheaper code reader: it doesn't know the codes. It knows there are codes, but it doesn't have them in the software to tell you what they are.
I presume the N/A are like what I see when I use my cheaper code reader: it doesn't know the codes. It knows there are codes, but it doesn't have them in the software to tell you what they are.
May be talking about OBD2 vs GM Codes here.
If you have an O'Reilly's in the area, go there to have them scan the codes. I believe they use higher end Bosch scanners that can probably read the GM codes.
You can also go to Wal Mart and buy the Hypertough Bluetooth scanner for your phone. You get the app free and can choose 1 free manufacturer codes. Select GM for free and you can buy if you have other makes in your fleet.
If you have an O'Reilly's in the area, go there to have them scan the codes. I believe they use higher end Bosch scanners that can probably read the GM codes.
You can also go to Wal Mart and buy the Hypertough Bluetooth scanner for your phone. You get the app free and can choose 1 free manufacturer codes. Select GM for free and you can buy if you have other makes in your fleet.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
